This study was aimed at investigating the effects of the transfer of metallic debris during an in vitro wear test on ceramic femoral heads articulating against metallic acetabular cups. In particular, Biolox® Delta ceramic femoral heads of two different diameters (32 and 36 mm, three samples of each set) were run for five million cycles onto a hip wear simulator using bovine calf serum as lubricant. Wear and degradation of Biolox® Delta Composite femoral heads were evaluated by a gravimetric method and by micro-Raman spectroscopy, which was used to investigate possible phase changes upon the particles deposit, by assessing the monoclinic zirconia content and quantifying the tetragonal → monoclinic zirconia transformation. Our results showed that after five million cycles, the 32 mm-acetabular cups lost a higher mass than the 36 mm-ones. Metal transfer was observed on all the Biolox® Delta ceramic femoral heads and determined a worsening of all roughness parameters. The micro-Raman analyses of the in vitro tested femoral heads confirmed the results previously obtained on retrievals, i.e. the stress related to metal transfer appeared a particularly severe condition able to induce the tetragonal→monoclinic zirconia phase transformation. The extent of the transformation appeared higher than that observed in vivo for Biolox® Delta-on-Biolox® Delta couplings. On average, the 36 mm-femoral heads seemed more detrimentally affected by metal transfer than the 32 mm-ones; one femoral head belonging to the first set of samples underwent the highest extent of phase transformation and the highest depth involved, which in the worn centre area appeared meanly higher for the 36 mm-components than for the 32 mm-ones.
|Titolo:||Transfer of metallic debris after in vitro ceramic-on-metal simulation: wear and degradation in Biolox® Delta composite femoral heads|
|Data di pubblicazione:||2017|
|Appare nelle tipologie:||1.1.2 Articolo su rivista con ISSN|